MAX 10 Projamming Issue 10M25SCE144I7G

[INITDONE]

Hello Team,

In one of our project , We are using Max 10 10M25SCE14417G device . On first Time , We able to Flash Device successfully without any Issue. Here I attached both working and non working screen shot.

But second time time on wards , We are getting the bellow error

Incompatible feature ID for Device 1 . Expected feature ID is 120 but fouL&42 126 Unrecognized device .

Exit code = 6 -- Unrecognized Device .

Here we are using JAM file and The same programming file only using all the time.

Can you please help me to resolve the Issue?

Thanks & Regards,

Ramesh S

[Fakhrul]

Hi INITDONE,

Have you tested it (the .jam file) on another Max 10 device? What's the behavior?

Try to make a new simple design, generate it into a .jam file, and try to configure it.

Regards,

fakhrul

[INITDONE]

Hi Fakhrul,

Thanks for the Reply.

We have only one Max10 device is there  and made very simple design with 11 IO pins , just  loop test only.

Tried with SOF and POF and JAM  file but all file are showing same error and error is below,

Error(16353): Expected the Max 10 device at index 1 to be of type analog, but detected device of type compact instead. Ensure that you are using the correct programming file.

configuration scheme is Internal Configuration

Configuration mode : Single compressed Image (3200Kbits UFM)

still not able to resolve the Issue. Please help us

Thanks & Regards,

Ramesh S

[Fakhrul]

Hi INITDONE,

Have you try to program your .pof file using Quartus Programmer?

Is your .pof file able to program and load into FPGA (configure)?

[INITDONE]

Hi Fakhrul,

Thanks for the Reply.

The issue is resolved once Dual configuration Intel FPGA IP is added into project.

Thanks & Regards,

Ramesh S.

[Fakhrul]

Hi INITDONE,

I’m glad that your question has been addressed, I now transition this thread to community support. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.