Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20640 Discussions

MAX10 Boot Problem

EEren
Novice
392 Views

On CFM0 - I have a boot image. With the boot I program a main image on CFM1.

First I switch to CFM0 with a micro controller pins

 

 

BOOT_SEL = 0
ENA = 0
Delay(100)
ENA = 1

 

 

Then I download the main image - main_0.rpd (with a big endian checkbox checked) .

After a successful image download I switch to CFM1

 

 

BOOT_SEL = 1
ENA = 0
Delay(100)
ENA = 1

 

 

And I see no response from FPGA.

 

What could be a problem? What do I miss?

 

The main image - should it include dual config module?

component dual_config is 
port (
		avmm_rcv_address   : in  std_logic_vector(2 downto 0)  := (others => '0'); -- avalon.address
		avmm_rcv_read      : in  std_logic                     := '0';             --       .read
		avmm_rcv_writedata : in  std_logic_vector(31 downto 0) := (others => '0'); --       .writedata
		avmm_rcv_write     : in  std_logic                     := '0';             --       .write
		avmm_rcv_readdata  : out std_logic_vector(31 downto 0);                    --       .readdata
		clk                : in  std_logic                     := '0';             --    clk.clk
		nreset             : in  std_logic                     := '0'              -- nreset.reset_n
	);
end component;

0 Kudos
3 Replies
JohnT_Intel
Employee
365 Views

Hi,


Have you trigger reconfiguration? When you mention nothing happen is it still stuck in CFM0 image or it is stuck in configuring CFM1 image?


0 Kudos
EEren
Novice
354 Views

I mean it switched to CFM1 page but no reaction from the main program. It seems like CFM1 loaded OK - STATUS and CONF_DONE pins behave as expected.

To analyze the problem further I did the following - created a combined pof file

first page - boot.sof (CFM01)

second page - main.sof (CFM1)

Then I burn the pof file, switch to CFM1 - and no reaction from the main program.

When I burn the main.pof only - everything OK.

 

Oh...seems like my stupid mistake. Now it's OK.

 

 

 

 

0 Kudos
JohnT_Intel
Employee
326 Views

Hi,


May I know how do you resolved the issue?


0 Kudos
Reply