Quartus II Cyclone IV DDR2_SDRAM PIN problem

[Altera_Forum]

Hi all, 

I am trying to use SOPC_Builder to build my NIOS system. But after the NIOS symbol is generated, I find that some pins which I can't find out in the datasheet of DDR2 SDRAM. So how to assign these pins correctly?  The following is the pins which does not exist,   DDR2_SDRAM_aux_full_rate_clk_out  DDR2_SDRAM_sux_half_clk_out  DDR2_SDRAM_phy_clk_out    Local_init_done_from_the_DDR2_SDRAM  Local_refresh_ack_from_the_DDR2_SDRAM  Local_wdata_req_from_the_DDR2_SDRAM    Reset_phy_clk_n_from_the_DDR2_SDRAM  Here is the hardware, software, nios2 system I used  Quartus II version 9.1 SP2 full version   Cyclone IV E: EP4CE15F17C7    Nios2 system:  CPU(clk : External clk =100MHz)  EPCS Serial Flash Controller(clk : External clk = 100MHz)  DDR2_SDRAM (64MB,8bit wide, Discrete Device, CAS 5.0, 1 Chip Select,   the parameters was Modified form Micron MT47H64M8CB-3)  PIO(clk : External clk = 100MHz)  sysid (clk : External clk = 100Mhz)  Can anyone help me to solve my problem, Thanks!!!

[Altera_Forum]

I have spent much time to solve this problem,but i still don't know how to assign pins

[Altera_Forum]

I have the same problem, who can give me some good suggestions? Thank you !

[Altera_Forum]

hi, 

do you run the tcl scripts for the sdram assign

[Altera_Forum]

I have run the tcl scripts,thank you for your reply.