- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I did successfully a few projects based on Cyclone III. Month ago I had to reprogram one of my board. I had new usb blaster. Old (broken mechanicly) and new was chinese but different. After configuring I recognised that PLL works 1000x slower than should . 10Mhz clock was changed to about 10khz. Because I needed only 10Mhz (my oscillator freq.) I use input clock for whole program. But it happens again during configuring new project. Could somebody tell me or it is something unexpected in Quartus (9.1 sp2) or usb blaster? I NEVER had such problem before.
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So you are saying that, you are programming the same programming file with different USB Blaster and the PLL is working slower than expected?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page