- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In your Quartus project, under "Assignments" -> "Device...", click on the "Migration Devices" button (bottom left). Then move devices from the left panel to the right. Quartus will then create a single set of report files that will support all the devices you've selected. This will include the .pin file which will tell you how to connect the pins you've identified on you PCB. Note that you still need to compile for a specific device to ensure the correct programming files are generated.
Cheers,
Alex
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
As per the pin connection guidelines you can connect NC pins to power, ground or signal trace. So there should be no problem. Kindly refer the page no: 12 of below document.
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/dp/max-10/pcg-01018.pdf
Regards,
Rs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page