- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
I'm using EPCS128 and having a problem with defining it's controller in Qsys / SOPC. When adding the EPCS controller, there is no place to insert the size of the Flash. The span that was automatically set is 0x800. :huh: How can I tell Qsys that I'm using 128Mbit Flash?? Thanks, Yan GLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This 0x800 span only includes epcs controller registers and bootloader code.
Actual flash memory is indirectly accessed by HAL drivers through these registers.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Cris.
I missed that on-chip memory for bootloader part...
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page