- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
I'm a new user of FPGA and It seems I have some problem with flash memory In programmer, when I downloading the program sof in FPGA, I don't have any problem, but when I tried to downloading the program pof in FPGA, so the memory, it won't work anymore. Anyone could help me and what should I check in the board. Thanks a lot, best regards.Link Copied
5 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
What board are you using?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- Hi, What board are you using? --- Quote End --- Hi, Thank you for your answer. I use a FPGA altera max 10 and I intrigue it in my own board
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
1. Did you selected correct internal configuration scheme in project settings? 2. Did you generate the .pof with correct ICB settings?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- Hi, 1. Did you selected correct internal configuration scheme in project settings? 2. Did you generate the .pof with correct ICB settings? --- Quote End --- I think my project setting is correct I don't see the second question, how could I check
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
What configuration scheme do you use? Did you read https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/hb/max-10/ug_m10_config.pdf (https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/hb/max-10/ug_m10_config.pdf) chapter "Configuring MAX 10 Devices using Internal Configuration" and followed exact steps described in this chapter? Could you describe what problem do you have? Device does not boot after .pof programming and repowering board or what?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page