Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

graphics display problem with STRATIXII EP2S180

Altera_Forum
Honored Contributor II
‎03-18-2009 01:11 PM
1,003 Views

hi, 

i have a problem with EP2s180: 

I made a design with Stratix II EP2S180 with whom I used a LANCELOT from Microtronix technologies for graphical display. 

in SOPC Builder I used a Lancelot component. I made the assignment of pins on the connectors of the stratixII card (Expansion Prototype Connector).  

the program runs correctly and the screen is excited but it display nothing. 

can someone help me resolves this problem :( 

BEST REGARDS 

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.