- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If I set the unused pins as "inputs tri-stated" or "inputs tri-stated with weak pull up" in Quartus II, do I have to connect the pins at the board level?
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you set the unused pins as "inputs tri-stated", you should connect the pins on the board level to VCC or GND or some signal for better noise immunity. If you set the unused pins as "inputs tri-stated with weak pull up", you do not have to connect the pin on the board.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page