unable to create symbol file for current file (Verilog HDL file) in Quartus IIweb13.1

Altera_Forum · ‎02-12-2015

Hi,

I am unable to create symbol file for current file (Verilog HDL file) in Quartus II web edition 13.1.

Compilation report shows 'Data not available'.

plz help me !

Altera_Forum · ‎02-12-2015

why not post the verilog file here...

Altera_Forum · ‎02-13-2015

Hi Tricky,

I am trying to run 'My_first_fpga' tutorial on my cyclone III starter board, verilog code is as below:

// This is an example of a simple 32 bit up-counter called simple_counter.v

// It has a single clock input and a 32-bit output port

module simple_counter (input clock , output reg [31:0] counter_out);

always @ (posedge clock)// on positive clock edge

begin

counter_out <=# 1 counter_out + 1;// increment counter

end

endmodule// end of module counter

Altera_Forum · ‎02-13-2015

have you created a project?

Altera_Forum · ‎04-18-2017

Hi,

I am also doing that tutorial and I have the same problem. I created a project (just as instructed). Chitranshvarun, were you able to resolve this issue?

Perhaps I should add that I am using this EP4CE6E22C8N FPGA rather than one of the recommended FPGAs...

Thanks in advance,

Chandran