Software Archive
Read-only legacy content
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17060 Discussions

Intel PRO Network Adapters WMI and CDM Providers

operaboffin
Beginner
637 Views
I'm trying to use the NCS2 suite to monitor hardware adapters and links which are teamed as part of a dual-redundant LAN implementation, so I can detect single failures from within a comms management application I'm developing. The IANet_PhysicalEthernetAdapterobject looks most useful, but although I can find a list of its properties (at http://support.intel.com/support/network/adapter/onlineguide/proinfo/APPS/WMI/DOCS/ethernet.htm), I can't find any definition of the properties' possible values and their significance. Does anyone know where these aredefined?
0 Kudos
1 Reply
Intel_Software_Netw1
637 Views
Greetings from Intel Software Network Support.
This is a bit outside the scope of what we ordinarily handle in our software development forums. Generally speaking,ifthe information you seek is not available on the Intel Hardware Design website, I would recommend contacting your Intel Product Representative for this information. Please ask to speak with a Field Application Engineer (FAE). If your company does not already have a contact via your purchasing department, please see the following URL: http://www.intel.com/buy/networking/design.htm under "Design Help"

If your location is not listed, please see an Intel Authorized Distributor (linked from the same URL).

Regards,
Lexi S.
Intel Software Network Support

Message Edited by intel.software.network.support on 11-15-2005 11:47 PM

0 Kudos
Reply