FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6262 Discussions

Cyclone V PCIe core: Fitter was unable to find Transceiver Reconfiguration...

Honored Contributor II

Hi there 


I have put a PCIe interface for the Cyclone V in Qsys (Quartus Prime 16.0), but when I compile I keep getting the same error: 


"Critical Warning (184043): Fitter was unable to find Transceiver Reconfiguration Controllers associated with the following 1 transceiver PHY IP component blocks" 


I have attached a screenshot of the Qsys setup. 



I would understand this if I had not actually connected the reconfiguration block AND the software driver. No matter what I do in the design, I still cannot get this warning to go away. What am I doing wrong? 


Thanks in advance for your help. 

0 Kudos
0 Replies