FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6355 Discussions

Device Does Not Show in Signal Compiler

Altera_Forum
Honored Contributor II
‎06-28-2011 08:24 PM
928 Views

Hi, 

 

When I click Scan Jtag in Signal Compiler, USB-Blaster shows up on the left, but the device (EP3C120) does not show up next to it. The same thing happens in SignalTap. 

 

This problem appeared after I (successfully) programmed the flash device with the .pof file for my design. After I restored the factory design, the problem remained even though the pattern of flashing LEDs seems to indicate that the factory design is restored. I'm using Matlab R2009a with DSP Builder 11.0. 

 

Any help would be greatly appreciated! 

 

Thank you, 

RUSHALE
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-28-2011 09:49 PM
207 Views

Hi, 

 

I closed that Matlab window and opened it again, and I also pressed the CPU_reset button. I'm not sure which solved the problem (probably the former), but its gone. 

 

Best Regards, 

RUSHALE
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.