Hi, I'm using the SDI_II_Intel_FPGA IP in Quartus 18.1. Does Cyclone 10 support DUAL LINK HD SDI mode? Thanks

[BIdro]

​I found in the IP's datasheet that CYCLONE 10 GX does not support the standard DUAL LINK HD-SDI, but in the support web page  ( https://www.intel.com/content/www/us/en/programmable/products/intellectual-property/ip/interface-protocols/m-alt-sdi.html ) it is explained that Cyclone 10 supports the standard DUAL LINK HD-SDI.

[CheePin_C_Intel]

Hi,

Thanks for highlighting this. As I understand it, you are observing discrepancy in term of support or not information between the user guide vs web. I can observe similar discrepancy when checking the latest 19.1 user guide vs web. For your information, I am currently consulting Factory to seek for further clarification. I will provide you an update on the progress by mid of next week or as soon as there is any valid finding.

Please let me know if there is any concern. Thank you.

[CheePin_C_Intel]

Hi,

Just to update you that I have managed to have discussion with Factory. For your information, it is recommended for you to refer to the user guide. The C10GX SDI II IP does not support the Dual Link HD SDI. I will feedback to our web team to update the web table accordingly. Sorry for the confusion and inconvenience.

Please let me know if there is any concern. Thank you.

Best regards,

Chee Pin

[CheePin_C_Intel]

Hi,

I believe the initial enquiry in this case has been addressed and I would set this case to close-pending at this moment. Thank you..

Best regards,

Chee Pin

[CheePin_C_Intel]

Hi,

As I understand it, it seems like you have reopened this case. Just would like to follow up with you if there is any further inquiries so that I could further assist you.

Thank you.

[BIdro]

Hi,

I understood.

​Thank you for the support.

[BIdro]

​Does Cyclone10 LP support HD-SDI Dual Link instead?

thank you

Bryan

[CheePin_C_Intel]

​Hi,

As I understand it from the SDI II IP user guide, it seems like it does not support C10 LP devices. Sorry for the inconvenience.

[BIdro]

​Hi,

thank you for the support.

best regard.

Bryan

[CheePin_C_Intel]

You are most welcome.

[BIdro]

​Hi,

I'm sorry but I have the last question.

Will an update(SDI_II_IP) be provided, that includes DUAL-LINK mode in Cyclone10 FPGAs?

Thank you.

Bryan

[CheePin_C_Intel]

Hi Bryan,

For your information, I am not aware of any plan to include support of Dual-Link mode in C10 devices. Sorry for the inconvenience.