- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am implementing Physical layer of a base band transmitter in simulink using DSP builder blocks. How can I use the clock signal in my design? I need it for implementing manchester encoder. Regards G ShahLink Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you need to connect a clock to all of the clock inputs.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the reply but the problem remains;
All the registered DSP builder blocks uses an internal clock. I can just instantialte the clock block, I cannot connect it to any other blcok. On the basis of the registered dsp blocks (which uses the internal clock) I have developed my logic. Now I want to connect the same clock to a non registered blcok. Kindly let me know if any body know it. regards shah- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
I also had a problem with the usage of the clock signal in DSP Builder. I tried to implement a clock recovery for a transceiver and I finally gave it up. I know how to set a clock, how to derive it or how to use a pll, but I think it is not possible with the DSP Builder to have the clock as "signal line" So if you have any clues I would be glad to hear them. I now implement basic logic in quartus II and import more complex funktions then from generated vhd files from DSP Builder.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page