FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6450 Discussions

Simple CVI -> CVO System

Altera_Forum
Honored Contributor II
‎05-08-2012 09:36 PM
1,096 Views

Hello, 

 

As the title implies, I am trying to design a simple pass-thru using the CVI and CVO components. 

 

I have a 1080p input with proper porches, actives etc; yet, I see incorrect timing parameters on the output of the CVO. For example I see a vertical front porch that is nowhere near what it should be (~30 versus 4). 

 

The video on the monitor looks good however, yet the format it nothing close to HD. 

Any suggestions on where to look? 

 

Thanks, 

Mike 

 

Edit: This is in version 10.1 of SOPC/Quartus/VIP. When trying the mode change via directly writing the CVO registers, there is no response even though the mode register indicates a match...
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎05-31-2012 04:25 PM
357 Views

do you work with embbeded sync or separate wire?

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.