- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi guys,
I have a big problem when I use the DCFIFO mega function. I need to store large amounts of data to achieve the data delay function. When I use the small FIFO(deep 1024),it works well. However when I increase the deeps of FIFO, it goes bad(deep 32768).(Writing and reading are not the same ) What happened ? I am confused! Is there anyone who meets the similar prolem? I'm looking forward to your suggestions! Sincere thanks!Link Copied
5 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ive had deep fifos, and never had a problem. You will need to post more details.
Have you changed any other settings, like the lookahead mode?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your reply!
yes, I turn on the show-ahead mode and my FIFO wide is 14bits. Did you set up any Timing Constraints for the FIFO when it gets big?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
not specifically, just make sure you have constraints on both clock domains.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you explain it in detail? I am a novice....:oops:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have same problem.
I use 32bit input and 8bit output FIFO, the fifo deep cannot exceed 1024 words (32768 bits).
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page