FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5990 Discussions

design example of p-tile avalon-mm ip for pcie for stratix 10 for quartus prime 20.1

ethanzsq
Beginner
150 Views

I have some questions when I run the example design:

1) Table 2 in user guide shows address and bar map for BAR Interpreter. Dose DMA controller always occupy a single BAR even if I set the size of this BAR larger than 4KB which I notice is the size of DMA controller(0-0xfff)

Resource Address Range           BAR
DMA         0x0 - 0x0FFFF             0
MEM0.s1 0x20000 - 0x27FFF   2
MEM0.s2 0x28000 - 0x2FFFF   2 

2)Should the BAR number of MEM0.s2 change to 4 if I set the total memory size of MEM0 to 64KB? Under such circumstances, Table 2 would be like this?

Resource Address Range           BAR
DMA         0x0 - 0x0FFFF             0
MEM0.s1 0x20000 - 0x2FFFF   2
MEM0.s2 0x30000 - 0x3FFFF   4 

3)Original Table 2 shows that there is no resource belongs to BAR4, but why can I read the configuration space of BAR4?

Thank you very much for your support.

0 Kudos
1 Reply
Rahul_S_Intel1
Employee
124 Views

Hi ,

 Just confirm your question, do face problem in reading BAR4 address 

Reply