FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
All support for Intel NUC 7 - 13 systems has transitioned to ASUS. Read latest update.
5853 Discussions

Problem with MAX 10 Configuration type

ZBien
Beginner
484 Views

I use Quartus Lite Prime Edition - 18.1.

 

I want to use Parallel Flash Loader to configure and program an external QSPI memory device for MAX 10 FPGA.

But on the menu: Assignments -> Device -> Device and Pin Options, on Configuration scheme - I only get: Internal Configuration option which is suitable only for internal MAX 10 FLASH memory.

If I change the device type to Cyclone, I do get Active Serial configuration scheme, which is suitable for external QSPI memory device.

But I want to use MAX 10 and I want to use external FLASH memory and not internal FLASH memory.

 

Please advice.

0 Kudos
1 Reply
YuanLi_S_Intel
Employee
213 Views

Hi Zvi,

 

Before this, please allow me to understand your scenario more clearly. So, in your design, you have a MAX 10 and you would like to program the MAX 10 with external QSPI using PFL IP? Is it so?

 

If it so, then i would not suggest to do so. MAX10 is a non volatile device and thus, only internal configuration is available as MAX10 can configure itself.

 

Regards,

YL

0 Kudos
Reply