Cyclone iv - triple speed ethernet set to RGMII

[alan_r]

I’m looking for an example of a Cyclone IV (Quartus Prime Standard & Platform Designer) using “triple speed ethernet” in RGMII mode.

Concerns:
output: tx_clk
input: rec_clk

Thanks,

--Alan

[paveetirrasrie_Intel]

Hi Alan Jayson,

Below picture attached shows variations for TSE Ethernet Cyclone IV devices. For RGMII setting, IP variation is 1000 Mbps Small MAC. By using the applicable, you will be able to generate design example for TSE.

Here's the link for TSE UG. You can refer more detail on how to generate design example on TSE UG.

https://www.intel.com/content/www/us/en/docs/programmable/683402/22-1-20-0-0/about-this-ip.html

Regards,

Pavee

[alan_r]

Hi Pavee,

The attached picture is not attached.

Thanks,

--Alan

[paveetirrasrie_Intel]

Hi Alan,

Sorry about that. You may refer to the TSE UG pg20 Table 14 Resource Utilization for Triple-Speed Ethernet for Cyclone IV GX Devices.

Regards,

Pavee

[paveetirrasrie_Intel]

Hi Alan,

Good day. Any update on this?

Regards,

Pavee

[alan_r]

I got link FAE from Arrow that helped alot.

https://www.intel.com/content/www/us/en/design-example/714768/cyclone-10-lp-intel-fpga-triple-speed-ethernet-and-intel-on-board-phy-chip-reference-design.html

Thanks,

--Alan

[paveetirrasrie_Intel]

Hi Alan,

I’m glad that your question has been addressed, I now transition this thread to community support. 

If you have a new question, feel free to open a new thread to get the support from Intel experts.

Otherwise, the community users will continue to help you on this thread. 

Thank you.