Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16557 Discussions

How to save and reload sources and probes configurations in Quartus II

whunt4
Beginner
1,287 Views

I am using Quartus II so I don't know if this is an issue with Quartus Prime or not. I can use the sources and probes megafunction, and read and write to the data values, but to make this useful, you have to group and rename the signals. After configuring groups and names, I can save the setup to a ".spf" file, but I can't find a way to read the file back in the next time I use the tool. Anyone been able to figure this out? Also, is there a TCL was to accomplish the same thing?

0 Kudos
1 Solution
sstrell
Honored Contributor III
490 Views

From Quartus, open the .spf file you saved.

View solution in original post

0 Kudos
4 Replies
sstrell
Honored Contributor III
490 Views

What do you mean by reading the file back in? Just program the device and reopen the .spf file, or program the device directly from the .spf file.

0 Kudos
whunt4
Beginner
490 Views

I opened the probes and sources tool and programmed the FPGA. This tool has no file open option, just save and save as.

0 Kudos
sstrell
Honored Contributor III
491 Views

From Quartus, open the .spf file you saved.

0 Kudos
whunt4
Beginner
490 Views

ah, that works. A bit obfuscated. I just always opened the probes and sources tool first.

0 Kudos
Reply