Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17267 Discussions

Quartus support cyclone II

Daniel19
Beginner
1,081 Views

HI
I have BORED DE2, Windows 10, 64 bit, I know version 13.1 Quartus is compatible with cyclone II, but version 13 does not support 64 bit.
what should I do?

0 Kudos
3 Replies
ak6dn
Valued Contributor III
1,065 Views

Don't know what you mean.

I have QuartusII Web 13.0sp1 installed both on a Win7 Pro 64b and a Win10 Pro 64b 21H2 system and it runs fine on either platform.

I use if for a TerAsic DE1 board that has a CycloneII EP2C20 part. No issues.

0 Kudos
ShengN_Intel
Employee
942 Views

Hi,


Quartus II 13.1 is supported for 64 bit operating system. Check this https://www.intel.com/content/dam/support/us/en/programmable/support-resources/bulk-container/pdfs/literature/rn/archives/rn-qts-131-dev-support-1.pdf (page 2)


Best Regards,

Sheng


p/s: If any answer from community or Intel support are helpful, please feel free to mark as solution and give Kudos.


0 Kudos
ShengN_Intel
Employee
921 Views

Since there are no further feedback for this thread, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you. Thank you.


0 Kudos
Reply