Solved: Re: Reversing a bus in SystemVerilog

AWilc1 · ‎11-10-2018

Is there a way to reverse a bus in systemverilog?

I am trying to do:

genvar j;

generate

for ( j=0 ; j < 256 ; j=j+1 ) begin

out[j] <= in[256-j];

end

endgenerate

But when I compile in ModelSim I get the errors:

** Error: (vlog-13069) near "[": syntax error, unexpected '['.

** Error: (vlog-13205) Syntax error found in the scope following 'out'. Is there a missing '::'?

I cannot see what is wrong here. Can anyone more familiar with SV see what is wrong?

Thanks.

dave_59 · ‎11-11-2018

The problem is with the procedural assignment statement inside your generate loop. Assuming out is declared as a wire, you need to change it to

for (genvar j=0j<256;j++)
     assign out[j] = in[256-j];

But there us a much simpler way of writing this without a loop using the streaming operator

assign out = {<<{in}};

dave_59 · ‎11-11-2018

The problem is with the procedural assignment statement inside your generate loop. Assuming out is declared as a wire, you need to change it to

for (genvar j=0j<256;j++)
     assign out[j] = in[256-j];

But there us a much simpler way of writing this without a loop using the streaming operator

assign out = {<<{in}};