Intel® SoC FPGA Embedded Development Suite
Support for SoC FPGA Software Development, SoC FPGA HPS Architecture, HPS SoC Boot and Configuration, Operating Systems
444 Discussions

ARM A9 bare matal IRQ priority can't work

TBaox
Beginner
1,344 Views

I use cyclone V HPS, and there is a problem in configuring interrupt priority. I gave OSC1 TIMER a higher priority, and after the program was executed, I found that it could not preempt the low priority external interrupt from FPGA. Look at the priority configuration MASK and binary point are lower 3 bits. Excuse me, where is my configuration wrong.

Inked微信图片_20210510110658_LI.jpg

微信图片_20210510111022.jpg

The OSC1 timer runs normally as shown in figure 2. after the interrupt from FPGA is enabled, the timer interrupt cannot run normally, as shown in figure 1

0 Kudos
12 Replies
EBERLAZARE_I_Intel
1,319 Views

Hi,

Is the timer interrupt that you mentioned also could not run normal if if interrupt from other sources other than FPGA?

0 Kudos
TBaox
Beginner
1,291 Views

I didn't try that.

But  IRQ from FPGA timer ip doesn't preempt the low priority external interrupt from FPGA pio,too.

So I think something wrong on my configation. 

0 Kudos
EBERLAZARE_I_Intel
1,275 Views

May I know which Quartus version you are using? Also how did you compile/setup your preloader files?

0 Kudos
TBaox
Beginner
1,262 Views
0 Kudos
EBERLAZARE_I_Intel
1,246 Views
0 Kudos
TBaox
Beginner
1,237 Views

Sorry,I can't open the second link.

 

 

0 Kudos
EBERLAZARE_I_Intel
1,221 Views

Hi,

 

Unfortunately, the link is no longer available.

 

May I know, how did you setup/configure the prioritization? Did you have the H2f/f2h bridges enabled?

0 Kudos
TBaox
Beginner
1,213 Views

I use this function and I have enabled H2f bridge and light H2F bridge, unuse f2H bridge. 

//set prioritization

alt_int_dist_priority_set(ALT_INT_INTERRUPT_F2S_FPGA_IRQ0,48);

 

 

0 Kudos
EBERLAZARE_I_Intel
1,194 Views

Hi,

 

The Priority interrupts, ID0-ID15, that can only be triggered by software called Software Generated Interrupts (SGI).

 

Unfortunately, we do not have any official document on how this can be done, thus please refer to below suggestion from other discussion on the SGI configuration:

https://stackoverflow.com/questions/20430733/inter-processor-interrrupts-in-arm-cortex-a9-how-to-write-an-handler-for-softw

https://stackoverflow.com/questions/41851975/enable-and-distribute-irqs-in-linux

 

 

 

0 Kudos
TBaox
Beginner
1,180 Views
0 Kudos
EBERLAZARE_I_Intel
1,149 Views

Hi,

 

I found the documentation below on the Preemption on section 3.3, could you take a look:

https://developer.arm.com/documentation/ihi0048/bb

 

0 Kudos
TBaox
Beginner
1,123 Views
0 Kudos
Reply