Hello everyone! I have DE1 board with cyclone II ep2c20f484c7 fpga, Quartus II 11sp1.
I've followed "Nios II Hardware Development Tutorial" from
altera.com site, and had problem in running project on the board. I always have messages:
Connected system ID hash not found on target at expected base address.
Connected system timestamp not found on target at expected base address. Ignoring this lead to
Using cable "USB-Blaster ", device 1, instance 0x00
Pausing target processor: not responding.
Resetting and trying again: FAILED
Leaving target processor paused
This is odd, because I programmed fpga with quartus II programmer without any problems.
I've search similar topics here, but I can't found solution.
Run through this tutorial 6 times, tired. Do not know what to do, help needed =)
