Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12612 Discussions

system ID / timestamp not found

Altera_Forum
Honored Contributor II
1,071 Views

Hello everyone! I have DE1 board with cyclone II ep2c20f484c7 fpga, Quartus II 11sp1. 

I've followed "Nios II Hardware Development Tutorial" from altera.com site, and had problem in running project on the board. I always have messages: 

Connected system ID hash not found on target at expected base address. Connected system timestamp not found on target at expected base address. 

Ignoring this lead to  

Using cable "USB-Blaster ", device 1, instance 0x00 Pausing target processor: not responding. Resetting and trying again: FAILED Leaving target processor paused  

This is odd, because I programmed fpga with quartus II programmer without any problems. 

I've search similar topics here, but I can't found solution. 

Run through this tutorial 6 times, tired. Do not know what to do, help needed =)
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
364 Views

Problem solved, incorrect pin assignment, I'm an idiot.

0 Kudos
Reply