CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
Success! Subscription added.
Success! Subscription removed.
Sorry, you must verify to complete this action. Please click the verification link in your email. You may re-send via your
profile.
I am planning on configuring this C3 device using the Active Parallel method with a Numonyx CFI flash device. Is there any way of having multiple configurations within the FLASH and choosing between them? If so how? Thank you, Rob
The Cyclone III will always load the same configuration from the flash at power up. But then, you can have it load a new configuration at another place. Have a look at application note 521 (http://www.altera.com/literature/an/an521.pdf).
