Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21611 Discussions

C3 - Ep3c80

Altera_Forum
Honored Contributor II
‎07-22-2009 02:39 PM
938 Views

Hi, 

 

I am planning on configuring this C3 device using the Active Parallel method with a Numonyx CFI flash device. Is there any way of having multiple configurations within the FLASH and choosing between them? If so how? 

 

Thank you, 

Rob
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎07-30-2009 06:39 AM
322 Views

The Cyclone III will always load the same configuration from the flash at power up. But then, you can have it load a new configuration at another place. Have a look at application note 521 (http://www.altera.com/literature/an/an521.pdf).

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.