Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20638 Discussions

Ctrl + C in NIOS shell

SK_VA
Beginner
591 Views

When I try to break a process by pressing Ctrl + C in NIOS shell. The process does not stop. Is there any settings to be done to accept Ctrl +C command in NIOS shell.

0 Kudos
1 Reply
Ahmed_H_Intel1
Employee
198 Views

Hi SANJU ALIAS,

The Ctrl+c used to terminate your GDB debugger session. No extra setting to be set for this command.

Please check the useful link below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/nios2/edh_ed51004.pdf

Regards,

0 Kudos
Reply