Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21324 Discussions

Ctrl + C in NIOS shell

SK_VA
Beginner
‎05-23-2019 09:08 AM
733 Views

When I try to break a process by pressing Ctrl + C in NIOS shell. The process does not stop. Is there any settings to be done to accept Ctrl +C command in NIOS shell.

0 Kudos

Link Copied

1 Reply
Ahmed_H_Intel1
Employee
‎07-05-2019 07:27 AM
340 Views

Hi SANJU ALIAS,

The Ctrl+c used to terminate your GDB debugger session. No extra setting to be set for this command.

Please check the useful link below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/nios2/edh_ed51004.pdf

Regards,

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.