Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

For a MAX10 CPLD, when a VCC brown-out condition is removed and the voltages are within the specified operating range, does the CPLD reenter configuration mode and get reconfigured? What the value of POR circuit trip points?

MMart22
Beginner
‎10-23-2018 04:20 PM
1,614 Views
 
0 Kudos

Link Copied

1 Reply
ShafiqY_Intel
Employee
‎10-29-2018 05:25 AM
913 Views

Hi,

 

Yes, Max 10 device will reenter configuration mode an get reconfigured if the voltage are within the specified operating range. The circuit keeps the entire system in reset mode until the power supply voltage level stabilized on power-up.

The power up voltage must be between 1.5V-3.3V during configuration. And the Power Supply Ramp Time (Tramp) must not exceed 10ms.

 

Thank you.😉

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.