- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Per "MAX 10 Schematic Review Worksheet 1.0" page 19, TMS and TDI should be puled-up to 2.5V for 3.3V JAG operation. Is it a typo? Can I pull them to 3.3V instead? Thanks, NoamLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I've not used the MAX10, but the same recommendation (2.5V pullup) exists for the Cyclone series. I think you can pull up to 3.3V, but watch out for overshoot which can destroy devices. I've seen some diode clamp recommendations to avoid this. Pulling up to 2.5V minimizes the potential for overshoot.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page