- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Quartus Programmer fail on first "Program" click with bemicro cv a9 board.
Anyone have same issue? If I click "Program" for the second time programming works..Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
no idea if that helps, but at the bottom of the Quartus main window there's a log area labelled "System". I mention this because it's easily overlooked, as usually the "Processing" log area is open by default instead (at least on my installation, it doesn't seem to switch to "System" automatically when I use the programmer). Maybe you get some helpful information from there. Best regards, GooGooCluster- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
System say
Error (209040): Can't access JTAG chain But when I click second times.. Info (209017): Device 1 contains JTAG ID code 0x02B140DD And all program fine
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page