- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi , i have problem with SOPC builder. On first picture label : "Error: cpu_0: Exception is too large for the selected memory" Project : https://yadi.sk/d/q4-scbq13gsbnd
Link Copied
6 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello
the reason is that your memory is too small. you have just 20 byte on onchip_memory2_0. what a hell do you think you can do with it.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- hello the reason is that your memory is too small. you have just 20 byte on onchip_memory2_0. what a hell do you think you can do with it. --- Quote End --- I changed the memory settings , nothing has changed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks , I solved this problem long ago , but now i have another. In IDE : image on board is newer than expected
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ok then, congratulations.
about your next problem. I don't know where/when you meet this message. you should describe detail.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- ok then, congratulations. about your next problem. I don't know where/when you meet this message. you should describe detail. --- Quote End --- In nios ii ide , when i try to run project
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
upload your project again if you can.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page