Stratix 10 SmartVID and Fixed PS

[EShum]

Hello,

We have a board populated with Stratix 10 1SG210HU2F50E2VG.

Device programming return errors. We found out that we have SmartVID device and a Fixed Voltage Power Supply without PMbus conection to S10.

Is any chance to run SmartVID device on this board?

[sstrell]

I want to say that if you disable the PMBus pins (Device settings -> Device & Pin options -> Configuration -> Configuration Pin options; first 3 in the list), it would work. But I've never tried it.

[EShum]

PMBus pins must be enabled for bitstream generation. Otherwise Programmer returns:

Error(19192): File <filename>.sof is incomplete - Power management settings are not set up appropriately on VID part

[Rahul_S_Intel1]

Hi Eugene, I have send you private message pls check it. Regards, RS