UFM Status Register Read Successful for burst reads?

[Altera_Forum]

I am doing burst reads to the UFM and I was wondering if (bit 2) in the UFM status register reports when a burst read is finished or if this after each read. 

 I am programming a MAX10.  -Chuck

[Altera_Forum]

Refer to Table 11 on page 24 of the 'max 10 user flash memory user guide (https://www.altera.com/en_us/pdfs/literature/hb/max-10/ug_m10_ufm.pdf)'. Bit 2 will only be set following a successful read. 

 Cheers, Alex

[Altera_Forum]

--- Quote Start ---  Refer to Table 11 on page 24 of the 'max 10 user flash memory user guide (https://www.altera.com/en_us/pdfs/literature/hb/max-10/ug_m10_ufm.pdf)'. Bit 2 will only be set following a successful read.  Cheers, Alex  --- Quote End ---    Thanks Alex.