Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
Need Forum Guidance? Click here

Search our FPGA Knowledge Articles here.
18963 Discussions

UFM Status Register Read Successful for burst reads?

Altera_Forum
Honored Contributor II
1,205 Views

I am doing burst reads to the UFM and I was wondering if (bit 2) in the UFM status register reports when a burst read is finished or if this after each read. 

 

I am programming a MAX10. 

 

-Chuck
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
91 Views

Refer to Table 11 on page 24 of the 'max 10 user flash memory user guide (https://www.altera.com/en_us/pdfs/literature/hb/max-10/ug_m10_ufm.pdf)'. Bit 2 will only be set following a successful read. 

 

Cheers, 

Alex
Altera_Forum
Honored Contributor II
91 Views

 

--- Quote Start ---  

Refer to Table 11 on page 24 of the 'max 10 user flash memory user guide (https://www.altera.com/en_us/pdfs/literature/hb/max-10/ug_m10_ufm.pdf)'. Bit 2 will only be set following a successful read. 

 

Cheers, 

Alex 

--- Quote End ---  

 

 

Thanks Alex.
Reply