Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20693 Discussions

Whether Winbond Flash supported by Quartus Programmer?

Safila
Beginner
‎05-10-2022 05:19 AM
806 Views

              We are using ArriaV 5AGXMB1G4F40 FPGA in our design.Earlier,the flash device used was “S25FL512”.Since the part is not available , we have replaced “W25Q512JVFIM”.

              While converting .sof to .jic using Quartus,the above mentioned flash has not listed as default.Therby,we have add the flash in the wizard under ” add device” category.

              After conversion,tried to flash .jic.We could able to program .jic successfully[Quartus programmer displays the status as successful].But config_done has not set.

             Kindly help us on this issue.

Preview file
53 KB
Preview file
56 KB
0 Kudos

Link Copied

1 Reply
YuanLi_S_Intel
Employee
‎05-11-2022 12:18 AM
777 Views

Seems like the setting on the flash is not correct. Just want to check if you are putting the correct command as per winbond datasheet? Also, have you probe the signal during configuration? We can get more clue there.


0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.