Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
19493 Discussions

Which IO standard needs to be used? 200 MHz 1.8 V

Altera_Forum
Honored Contributor II
828 Views

Hi,  

 

I need to drive an input at a board which is connected to my board through samtec connectors at 200 Mhz, 1.8V, single ended. In cyclone 10 GX device, Which IO standard should I pick?
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
96 Views

Hi, 

 

Is 200 Mhz, 1.8V are maximum rating what connector can withstand? 

 

You can use 1.5-V LVCMOS and 1.8-V LVTTL/LVCMOS. 

Refer cyclone handbook volume 1 (https://www.altera.com/en_us/pdfs/literature/hb/cyc/cyc_c51008.pdf). 

 

Best Regards, 

Anand Raj Shankar 

(This message was posted on behalf of Intel Corporation
Reply