Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21602 Discussions

square wave from cyclone 2 board

Altera_Forum
Honored Contributor II
‎02-10-2016 09:51 AM
938 Views

i have compiled a code to generate a square wave using Quartus2,downloaded into a cylone2 board. In simulation, the square wave was visible and accurate. How can i connect the fpga board to an oscilloscope to view the square wave? 

pin diagrams in data sheet weren't that useful. can somebody please show us how to assign pins in the GPIO modules?
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.