- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ssWe have an Intel Modular Server, Model MFSYS25V2 and I will be replacing the SCM for this unit on Tuesday Morning and have a couple of questions:
1) Once our virtual Network servers are shut down, I was told that I need to go into the Modular Server Control web page and shut down the Servers under system. If our Virtual Network servers are shut down, how will I be able to get to the Modular Server Control web page? will I still be able to access it through the ip address of 10.10.1.10?
2) Once the swap is made and I power up the Modular Server how do I get to the Modular Server Control Web page to start the servers again? The answer to question one most likely answer this question but I do want to ask just in case it is different.
I was assuming that once the Intel Modular Server was powered up the servers would power up as well however when I was talking to the tech support person the other day he told me the steps to take to swap out the SCM. I was not thinking about once the virtual servers were powered off how do I get into the Modular Server Control web page to ask him this question and today is Sunday they are not there to answer the question and I would like to swap out the SCM tomorrow morning.
a little information that might help out on answering the questions:
we have 2 domain controllers. DNS set up on them.
SonicWall router DHCP and gateway set up on this unit.
Any help would be greatly appreciated.
As Always, thanks,
Robin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The Modular Server Control web page runs on the CMM, and it isn't dependent on compute modules. So answers to your both questions are Yes.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I do want to mention that a couple months back we had a power failure that lasted about 3 hours. Everything shut off once the UPS battery died. When the power came back on, I did not do anything to start the Modular Unit, the compute modules (server) or the virtual servers. so now I am wondering if I have to go into the Modular Server Control and start the Compute Modules. anyone out there know?
thanks again.
Robin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The Modular Server Control web page runs on the CMM, and it isn't dependent on compute modules. So answers to your both questions are Yes.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Edward.
Plans changed so I did not swap out the SCM this morning we are hoping to do it tomorrow moring.
![](/skins/images/7FC17B7B85029576C25F1E43CE255B51/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page