- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
How can I setup and run my first program using Java to build my first aplicattion using RealSense? I tried a lot, but I am stuck on.
Someone can help with this?
Thanks,
My best regards,
Eduardo
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Where are you stuck on? Also I hope you're not using Eclipse/Android Studio as the IDE for your application.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
i am using realsense with c# (so i haven't tried what i am about to propose) but have you followed the steps described below?
https://software.intel.com/sites/landingpage/realsense/camera-sdk/v1.1/documentation/html/index.html?devguide_java_application.html ;
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nnice! i wanna try this
Yiannis C. wrote:
Hi,
i am using realsense with c# (so i haven't tried what i am about to propose) but have you followed the steps described below?
https://software.intel.com/sites/landingpage/realsense/camera-sdk/v1.1/d...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to run the example of CameraViewer.java available on the $(RSSDK_DIR)/framework\Java\FF_HandsViewer . Now I can compile using the Eclipse IDE, but there's an error that I can figure out.
See my print screen about the error:
I am always receiving the status PXCM_STATUS_ITEM_UNAVAILABLE and the error on line 44. Did you know about this problem?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page