FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6491 Discussions

MAX10 dual configuration IP core

ZBien
Beginner
787 Views

On Intel MAX10 configuration guide - figure 3 describes the way that each one of the two burned images are loaded. Can this process described in figure 3 be done without using the dual configuration IP? If yes then what is the dual configuration IP needed for?

0 Kudos
4 Replies
ShafiqY_Intel
Employee
563 Views

Hi ZBien,

 

Dual Configuration IP is needed to trigger reconfiguration and config_sel (image 0 or image 1).

In other words, you need to have Dual Configuration IP to switch between images.

 

Thanks

 

0 Kudos
ZBien
Beginner
563 Views

Just to be sure: Is it possible not use the Dual configuration IP in the implementation, but still to have the next process: Trying to load the first image after power up but if a first error occurs then trying to load the second image?

0 Kudos
sstrell
Honored Contributor III
563 Views

No, you need the IP to do this.

 

#iwork4intel

0 Kudos
ShafiqY_Intel
Employee
563 Views

You're right @sstrell​ . Dual Configuration IP is needed for RSU.

 

Thanks

0 Kudos
Reply