FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6359 Discussions

Problem with using line-in and line-out

Altera_Forum
Honored Contributor II
‎03-23-2012 04:21 AM
981 Views

My board is Stratix II EP2S60. I want to using the line-in and line-out for inputting and outputting the music. However, I can't find which block in the simulink is referred to them. Besides, is this possible to separate the input music to right and left channel in the simulink model planing?

0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎03-30-2013 04:39 PM
254 Views

Who needs simulink to separate two channels? I'd be surprised if there was a "model" at all to interface a ADC and when using a codec, you will have to get familiar with it's interface and most proably take a core. A simulink block is nothing more than that, apart from a graphical wrapper. In stereo data stremas with PCM / S/PDIF you will find LR occuring in an alternating way

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.