Why got Error when try to upgrade QSYS from Standard 18.1 to 19.1. some of "module not found ".

[BAmar1]

I have design for MAX10 include Qsys with Nios  running on Quartus 18.1 .

I try to run on Quartus 19.1 and upgrade all IPs. the upgrading successful

but failed when try to Generate RTL . the Error is "xx module not found "

I Have all licenses . the design works on 18.1 .

[sstrell]

What module was not found? Can you attach a screenshot of the error(s) and your Platform Designer system? Are there errors in the Platform Designer Messages window before you try to generate the system?

#iwork4intel

[SyafieqS]

Hi Beny,

Could you provide the error message(s) if possible eg screenshot

[BAmar1]

its not only one module . if I remove the failed module . its failed in second module .

here is the error

[BAmar1]

[BAmar1]

[AAjit2]

Which system are you using? Is it Windows or Linux?

[SyafieqS]

Hi Amar,

Try to upgrade the IP one by one instead of upgrading all at a time. Refer to link below for details. Then regenerated the hdl again. Below are few links that might be helpful for your reference.

https://www.intel.com/content/www/us/en/programmable/quartushelp/17.0/hdl/mega/mega_upgrade_ip.htm

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-qpp-platform-designer.pdf (p58)

Thanks,

Regards

[BAmar1]

we used Linux system ,

when running only upgrade , All IP was upgraded to 19.1 . but when generate HDL its failed .

any way I will try upgrade one by one .