Cyclone 10 compiled pin out does not seem to match the cadence schematic symbol

[ericmtzr]

We working on a design using a Cyclone 10 10CX085YF672E6G and his compiled pin out does not seem to match the cadence schematic symbol.

For example the compiled design has pin K4 as an LVDS output, but the schematic symbol shows it as a No Connect

We need to know why there are two contrasting definitions for pin K4.

Also I have attached the pinout listing excel file, note I am using the F672 (Go to the F672 page, line 227 you will see pin K4 shown that it can be used as LVDS (which it is) or for DDR etc)

[AminT_Intel]

Hello,

I cannot see the uploaded document on this forum. Can you please share me files that you mentioned?

Thanks.

[ericmtzr]

Hi,

Thanks for your support,

I attached the file.

Regards.

[AminT_Intel]

Hello,

Thank you for sharing the pin-out file. Can you also share the schematic that you are referring that shows pin K4 as NC?

Thank you.

[ericmtzr]

Hi,

We are going to try to get the schematic, since it is a private project.

As soon as we have the schematic we send it to you.

Regards.

[ericmtzr]

Hi,

I attached the schematic, the NC block is in section 7 (page 5), and K4 is on the left side near the bottom.

Regards.

[AminT_Intel]

Hello,

May I know where specifically did you get this Intel OrCad symbol site? The reason I asked this I wanted to make sure that you are referring to the right schematic of your selected device.

Thank you. 

[ericmtzr]

Hi,

I attached a document with the information that you request, please tell me if you need more information.

Regards.

[AminT_Intel]

Hello,

Thank you for the detailed information. I have escalated this issue to the relevant team. 

Thank you.

[AminT_Intel]

Hello,

The team has been informed on this issue. We will let you know when the updated version is available.

Thank you.

[ericmtzr]

hi,

Excellent, thank you. Question, will you have any estimated release date for this update?

Regards.

[AminT_Intel]

Hello,

I have been informed that the schematic symbol will be updated by the end of today. Please let me know if you are able to download the latest version.

Thank you

[AminT_Intel]

Hello,

Is eveything good on your end? I will close this case in 3 days if there is no more concerns.

Thank you.

[ericmtzr]

Hi,

At the moment I have no response from my client, he is in trainings all week.

Could you tell me if the new version was already released?

[AminT_Intel]

Hello,

I have been informed from my team that they have updated it on the same day I posted my last reply.

Thanks.

[ericmtzr · Accepted solution]

Hi,

Thanks for you help, they tell me that they have already downloaded the new version and are carrying out the tests.

That's all for now, thank you very much.

Regards.

[AminT_Intel]

 I’m glad that your question has been addressed, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.