Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16606 Discussions

using UART to communicate between fpga and pc

MFort6
Beginner
‎07-30-2020 12:51 PM
604 Views
 

Hi

i am using Altera Stratix® V GX FPGA (5SGXEA7N2F45C2) and i have designed the UART program to communicate between the fpga and my pc. and the compilation was a success, but the problem is when i try to assign the UART tx, rx  pins. i can't find any in the data sheet. so i need to know is there any other way or do i need to change the bord?

Thank you

 
 
0 Kudos

Link Copied

1 Reply
ak6dn
Valued Contributor III
‎07-31-2020 11:27 AM
594 Views

See my reply in the Programmable Devices forum, as you posted the same question in both.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.