Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20644 Discussions

Use factory's image, it restart againand aganin after it work few time

CPwb0
Beginner
438 Views

we need update ep4c's fpga and lt's flash epcs64, so I learn an603 use factory image and application image, factory's baseaddr is 0x000000, application base is 0x400000, application can work well, but i find fpga restart again after it work well few time, if i don't use factory's image, my application can work fine long time, once i add factory's image and appliction's image together, it restart again after it work few time, why? 

0 Kudos
1 Reply
ShafiqY_Intel
Employee
232 Views

HI CPwb0,

 

When you convert your programming to .pof file, try to TICK both of "Disable EPCS/EPCQ ID check" and "Disable AS mode CONF_DONE error check" option.

 

Go to File > Convert Programming file > Advanced.. > "Disable EPCS/EPCQ ID check" / "Disable AS mode CONF_DONE error check"

 

I hope this will help.

 

Thanks

0 Kudos
Reply