Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21157 Discussions

timing report in quartus

CHung
Novice
1,099 Views

Hi,

Sometimes I found that timing reports in Timing Analyzer differs from timing Summary in Compilation Report.

For example, the Setup Summary at 900mV 100C corner is following figure.

CHung_0-1597197097094.png

The first one is PCIe clock, and slack is -0.693ns.

But, when I open Timing Analyzer and report timing of this clock,

it shows no timing violation.

CHung_2-1597197417781.png

The worst path is 0.048ns:

CHung_1-1597197146423.png

Does anyone know the reason?

Thanks.

0 Kudos
3 Replies
sstrell
Honored Contributor III
1,082 Views

That's certainly strange.  Can you right-click the failing clock(s) in the compilation report and generate a timing report from there?  Perhaps your report_timing command is not exactly matching up with what is shown as failing in the Compilation Report.

#iwork4intel

0 Kudos
CHung
Novice
1,074 Views

Hi @sstrell 

You are right.

The command generated from compilation report is different from mine.

My report_timing command set both startpoints and endpoints.

Thanks.

0 Kudos
KhaiChein_Y_Intel
1,062 Views

Hi,


Since your question has been answered, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


Best regards,

KhaiY


0 Kudos
Reply